Flashforge Creator3 - Filament

Creator3 User Guide | www.flashforge.com 400-699-1063
18
Tools
Tap [Tools] to enter tools interface.
1.Filament: To load/unload the filament.
2.Level: To adjust the build plate.
3.Home: To make the X, Y and Z axes back
to the zero point.
4.Manual: To manually adjust the positions
of X, Y and Z axes.
5.Setting: To implement relevant function
setups.
6.Status: To check the real-time status of the
printer.
7.About: Information about the printer.
8.Back
Filament
1.Load
；
2.Unload
；
3.Load-Left Extruder
；
4.Load-Right Extruder
；
5.Unload-Left Extruder
；
6.Unload-Right Extruder
；
7.Begin:Tap [Begin] to start load/unload
filament on Left/Right extruder.
8.Back.
1
2
3
4
6
5
7
8
1
2
3
4
5
6
7
8