Flashforge Creator3 - Print from USB Stick

Creator3 User Guide | www.flashforge.com 400-699-1063
76
● After finishing transferring, the printer will heat up automatically. And when heating
finishes, the print will start to build the model.
7.2.3 Print from USB Stick
①Insert your USB stick with target .g or .gx file to your Creator3. .
②Turn on the Creator3. Make sure the build plate has been leveled and the filament is
loaded.
③ Tap [Print] and then tap the USB Stick icon in the middle. The file(s) will be
displayed on the screen. Select the file you want to print and tap [Print]. The file will
be transferred to the printer.
④ And the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.
Abort：To stop heating and printing. Once you tap [Abort], the process is irreversible.
Pause：To suspend the print job, you can tap it again to resume it. You can use this
function when you want to change the filament halfway.
7-11