Flashforge Creator3 - Tools in Print Interface; Details Interface

Creator3 User Guide | www.flashforge.com 400-699-1063
16
To set Extruder/Platform temperature during
printing:
After temperature has reached target
temperature, temperature figure will be
underlined in print interface,
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
Tools in print interface
Filament: To change filament during
printing. (Note: You need to suspend
printing first.)
Light off:
To turn off the light during printing.
 Details: To check the details interface
during printing.
Details Interface
a.Printing speed: To change printing speed
during printing by tapping the underlined
speed figure.
b.Filament used
c.Time needed
d. Z axis position
To set the printing speed during printing:
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
1
2
3
a
b
c
d
e