Flashforge Creator3 - Loading Filament into Extruder

Creator3 User Guide | www.flashforge.com 400-699-1063
41
4.2 Printer Start-up
4-3
(4-3) Insert the power supply into the power input on the back of the Creator3 and
plug the power cord into an electrical outlet.
4.3 Loading Filament
For stable filament loading and proper device protection, you need to install the
filament guide tube properly.
4-4
(4-4) Take out the filament guide tube, thread the filament through the Filament
Detecting Equipment.