Flashforge Creator3 - Chapter 4: Hardware Assembly; Filament Cartridge Installation

Creator3 User Guide | www.flashforge.com 400-699-1063
40
Chapter 4: Hardware Assembly
Your Creator3 has been installed before leaving factory, you can start up the Creator3
for printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
4-1
(4-1) The filament cartridge is on both sides of Creator3. Lift the cartridge out of the
Creator3.
4-2
(4-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feeds from the bottom of the spool towards the top )
Filament Detecting
Equipment in the black.