Flashforge Creator3 - Page 72

Creator3 User Guide | www.flashforge.com 400-699-1063
72
Preview: If you check the [Preview] box, you can preview your model after slicing is
done.
Print When Slice Done: If you print via USB cable, you can check the box, while if
you print via USB, you should not check the box.
Machine Type: FlashForge Creator3
Material Right: Choose the right extruder filament material.
Material Left: Choose the left extruder filament material.
Supports: If you print a model with supports, you should click the inverted triangle
and select [Enable].
Raft: You are suggested to select [Enable].
Resolution: You are suggested to select [Standard]
More Options: You are suggested to keep them default.
Click [OK] to select the path to save the Gcode file. You can rename the file as you
like and save it as a .g or .gx file, click [Save] to generate a Gcode file.
Note: .gx files are available for preview while the .g files are not. They are displaying
as follows:
g. Files gx. Files
Next, we are going to print the model.