Flashforge Creator3 - Page 31

Creator3 User Guide | www.flashforge.com 400-699-1063
31
perpendicular to Y axis in the middle of
the platform at coordinates(-100,0).
4. Choose whether the two lines
coincide: Tap[Next] to choose whether
the two lines coincide: Yes/No.
5.Adjust the deviation value:
Tap [Next] button.
Tap [-] button and [+] button to adjust
the deviation value, the position of left
extruder to print a straight line on the
platform moves to the arrow direction.
After adjusting the deviation value, Tap
[Recalibration] button to do the
calibration.
Tap [Skip] button will skip the prompts
and directly adjust deviation value.
Tap [Recalibration] button to do the
calibration.
After recalibration, if the two lines
coincide, click the [OK] button.
Y axis calibration completed.
3
3
4
5