Flashforge Creator3 - Page 61

Creator3 User Guide | www.flashforge.com 400-699-1063
61
③
Material type: Choose according to the type of model
④ Supports: When print suspended structure models, support is necessary. Click
[supports] to create support part for the printing.
⑤
Raft: This function will help the model to stick well on the platform.
⑥ Wall: During dual color printing, this function will help to clear the leaking
filament of another extruder.
⑦
Brim: Expand the outline of model’s bottom layers to a Brim which helps anchor
the edges of the model to the plate to avoid warping.
⑧Resolution：You have three resolution solutions (with default setting)to choose from,
high resolution is corresponding with slow printing speed, opposite for the low
resolution. For PLA printing, an extra solution “Hyper” is available.
⑨ More options: Click [More options] to set for layer, shell, infill, speed and
temperature. Different resolution solution is corresponding to different defaults, click
[Restore Defaults] to back to default setting.
● Layer Height
a. Layer Height: Layer thickness of the printing model. With a small value, the
surface of the model will be smoother.
b. First Layer Height: This is the first layer of the model, which will affect the
sticking performance between the model and platform. Maximum is 0.4mm, usually
the default is OK.
● Shells: Contains the outside shell value, capping layer value (under vase
pattern, top solid layer setting is invalid.)
a. Perimeter Shells: Maximum is 10.
b.Top Solid Layer: Maximum is 30, minimum is 1.
c. Bottom Solid Layer: Maximum is 30, minimum is 1.