6 Mounting
FLUXUS F502TE 6.1 Transmitter
25
UMFLUXUS_F502TEV1-5EN, 2020-05-29
Mounting on a pipe > 2''
The pipe mounting kit is fixed to the pipe by using tension straps (see Fig. 6.4).
• Insert the tension straps (3) into the holes of the pipe mounting plate (1) and the instrument mounting plate (2).
• Fix the pipe mounting plate and the instrument mounting plate to the pipe using the tension straps.
• Use the screws to fix the transmitter to the instrument mounting plate.
Caution!
The edge of the tension strap is very sharp.
Risk of injury!
→ Debur sharp edges.
→ Wear the required personal protective equipment. Observe the applicable rules.
Fig. 6.4: Pipe mounting with tension straps
1 – pipe mounting plate
2 – instrument mounting plate
3 – tension strap
1
1
2
2
3
To Next Page
Loading...
