6 Mounting
6.2 Transducers FLUXUS F502TE
2020-05-29, UMFLUXUS_F502TEV1-5EN
38
• Repeat the steps to fix the second rail (see Fig. 6.26).
Step 5: Installation of the transducers in the mounting fixture Variofix L
• Press the transducers firmly into their clamping fixtures in the covers until they are tightly fixed. The transducer cables
show in opposite directions (see Fig. 6.27).
• Adjust the transducer distance displayed by the transmitter (see Fig. 6.28).
• Fix the transducer cables with the strain relief clamp to protect them from mechanical strain (see Fig. 6.28).
• Stick coupling foil (or apply some coupling compound for a short-term installation) on the contact surface of the transducers.
The coupling foil can be fixed to the contact surface with some coupling compound.
• Put the covers with the transducers on the rails.
• Correct the transducer distance, if necessary.
Fig. 6.25: Ratchet clasp with tension strap
1 – sense of rotation
2 – edge
3 – lever
4 – clasp screw with slot
Fig. 6.26: Pipe with 2 rails
Notice!
The arrows on the transducers and the covers have to point in the same direction.
Fig. 6.27: Installation of the transducers in the covers
1 – cover
2 – transducer clamping fixture
1
2
4
3
4
1
2
To Next Page
Loading...
