The Bootup Process
432-0012-00-10 Version 100 December 2015 14
Powering the JCU II
When the JCU II is receiving power, the Power button will
be lit amber. When the button is pressed for
approximately three seconds, the JCU II will turn on and
search for cameras on the network.
On the LCD screen, Starting, then Searching… is
shown. When a camera is found, the message changes
to Connecting…, which continues to flash until the
connection process completes and is replaced by the
camera ID, such as M400. When more than one camera
is found on the network, the JCU II attempts to reconnect
to the last camera it was connected to, or if it has not
connected to a camera, it will prompt the user to select a
camera.
Important: Fully establishing a connection may take up to three minutes. Please be patient while
the system verifies each component.
Power
LCD
screen
Select
camera
Scroll up
or down
To Next Page
Loading...
