Page 34CWT Compact S4 Touch Installation & Maintenance Manual for CWT 1.0-0Issue 3
Product description
Print side
preprint is not recommended in the black mark zone on the inner side unless the
above conditions are met.
Paper low sensor area
No preprint is allowed on any side of the paper in a 2-mm wide area from the edge
of the roll.
4.5.3
Black mark location
The GeBe printer uses a different location for the black mark the Zebra printer in
older machines.
Verify that you use the correct type of paper.
Warning:
When using black mark, you cannot use rolls for a Zebra printer in a GeBe printer
as the black marks are on different locations on the paper
Figure 18, Paper with both Zebra and Gebe black marks
To Next Page
Loading...