FLOWBIRD CWT Compact S4 Touch - Installing the Terminal; Mounting the Pedestal in Its Foundation

Page 56CWT Compact S4 Touch Installation & Maintenance Manual for CWT 1.0-0Issue 3
Installation
Unless otherwise agreed, the customer is responsible for providing an appropriate
12V battery. For CWT Compact terminals connected to the grid power supply, a
battery capacity of 17 Ah is required. Terminals equipped with a solar cell panel
require at least 45 Ah.
The customer is responsible for installing cables for terminals that will use the grid
power supply. When delivered, terminals are ready to be connected to the power
supply used at the installation site. It is up to the customer to ensure that the
correct type of battery charger and fuses are used.
Note:
The maximum total power consumption depends on the configuration of the
terminal.
5.2 Installing the terminal
Due to its heavy weight the terminal is usually transported in two pieces to the
installation site where the pedestal is secured to a concrete base or floor before
the cabinet is mounted on top of the pedestal.
Provided there is an appropriate lifting device or a hand cart at hand, the entire
terminal can be installed as a complete unit.
5.2.1
Mounting the pedestal in its foundation
WARNING:
Lifting the pedestal, the cabinet, or the complete terminal, requires two or three
persons due to the heavy weights.
WARNING:
Before the terminal has been secured to the foundation, there is a risk of the
terminal tipping forward, especially when you open the cabinet door.
· Place the terminal at the site that has been prepared. see Site preparations
for instructions.
· Fasten the terminal with 4–8 expansion screws or mount the terminal on an
existing base anchor or similar using the appropriate nuts and washers.
Important:
The function of the coin system and the water drainage (door shelf) may be
interrupted if the terminal leans more than a couple of degrees in any direction.
51