EasyManua.ls Logo

Flowserve Limitorque Accutronix MX - Restoring Power with New Control Module; Terminal Block Assembly

Flowserve Limitorque Accutronix MX
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
5.3 Restoring Power to Actuator with New Control Module
Figure 5.12 – Restoring Power to Actuator with New Control Module
5.4 Terminal Block (MX-05, 10, 20, 40, 85 & 140)
Table 5.3 – Terminal Block Parts List
Part Number Description Qty.
1-20 O-Ring 1
1-21 Retaining Ring 1
1-43 Pan Head (M3x4) Plastic Screw 2
8-15 Terminal Block 1
8-16 Self-Lock Combo Head Screw (M3x5) 48
8-17 Self-Lock Combo Head Screw (M5x8) 3
8-18 Cover Plate 1
8-19 Pan Head Self-Tapping Screw 2
8-20 Control Wiring Harness 1
Figure 5.13 – Terminal Block
5-18
Flow Control Division
Limitorque Actuation Systems
Electronic Assemblies
8-15
8-16
8-18
8-19
1-20
1-21
8-17
8-20
1-43
Yes
No No
Yes
No
No
Yes
Yes
Yes
No
No
Yes
Yes
UNIT SIZE
MX-05-OK?
VOLTAGE
460 VOLT-OK?
Hz
60 Hz-OK?
ACTUATOR RPM
12/18-OK?
S/N
0------OK?
COLD (-50ºC) UNIT
YES/NO -OK?
LOAD DEFAULT
UNIT SETTINGS?
INITIALIZE?
LOAD COLD TEMP
DEFAULTS?
INITIALIZE?
Answer “No” until the
correct unit size is
displayed. Refer to
nameplate.
Answer “No” until
the correct voltage
is displayed. Refer
to nameplate.
Answer “No” until
the correct frequency
is displayed. Refer to
nameplate.
Answer “No” until
the correct RPM
is displayed. Refer
to nameplate.
Answer “No” until the
value is displayed and
then “Yes” to enter.
Refer to namplate for
S/N.
Answer “No” to
select normal
temperature
parameters, -
30ºC to +70ºC.
Answer “Yes” to select arctic
temperature parameters, -
50ºC to +60C.
Answer “Yes” to
load default
settings. Unit will
now have factory
default settings.
Please refer to Limitorque Accutronix
MX Customer Connection(s) Diagram
(#L2180) reverse side (located on the
inside of the terminal compartment
cover) for customer default
configuration.
Answer “No”
to change.
Answer “Yes”
to save
settings.
Answer “No”
to change.
Answer “Yes”
to load cold
tem defaults.
Answer “No”
to change.
Answer “Yes”
to save
settings.
No
Yes
No
Yes
No
Yes

Table of Contents

Other manuals for Flowserve Limitorque Accutronix MX

Related product manuals