Flowserve Limitorque Accutronix MX - Encoder Assembly

Electronic Assemblies
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
Remount all removed subassemblies according to the remounting instructions in the following order:
1. Terminal block (subassembly #15). (See Section 5.4.2.)
2. Control module (subassembly #8). (See Section 5.2.2.)
3. Accutronix control panel (subassembly #7). (See Section 5.1.2.)
4. Motor (subassembly #4). (See Section 4.1.2.) If the motor voltage has changed, please see Section
5.2.3., Step 10 to ensure the voltage jumper on the power board is located in the proper slot.
5.6 Encoder (MX-05, 10, 20, 40, 85 & 140)
Table 5.5 – Encoder Parts List
Part Number Description Qty.
1-6 Encoder Assembly 1
1-36 Socket Head Cap Screw (M4x16) 3
6-11 Input Gear, 78-tooth (I.D. 3 through 8) 1
6-24 Input Gear, 69-tooth (I.D. 1 or 2) 1
Figure 5.15 – Encoder
Table 5.6 – Encoder Drive Sleeve Speed
Drive Sleeve Speed I.D. 1 2 3 4 5 6 7 8
50 Hz. RPM 15
2
22 33 43 65 84/110
1
127/143
1
165
2
60 Hz. RPM 18
2
26 40 52 77 100/131
1
155/170
1
200
2
NOTE: MX units with Drive Speed I.D. 1 or 2 require an optional input gear. Reference the
Output RPM block located on the MX nameplate and cross-reference in table above to
determine the unit Drive Speed I.D.
NOTE 1: MX-85 & 140 only.
NOTE 2: N/A MX-85 & 140.
5-27
Flow Control Division
Limitorque Actuation Systems
1-6
1-36
6-24
(MX units with Drive
Speed I.D. 1 or 2 require
optional input gear).
Reference table below
to determine your actuator
requirements.
6-11
(MX units with Drive
Speed I.D. 3 thru 8 require
standard input gear).
Reference table below
to determine your actuator
requirements.