Need help?Do you have a question about the Flowserve Limitorque Accutronix MX and is the answer not in the manual?
General| Type | Electric Actuator |
|---|---|
| Application | Valve Automation |
| Control | Digital |
| Communication Protocols | Modbus, Foundation Fieldbus, Profibus |
| Diagnostic Capabilities | Advanced Diagnostics |
| Voltage | 24V DC |
| Enclosure Rating | NEMA 4X |
| Output Signals | Digital |
| Certifications | ATEX |
Outlines the manual's structure and purpose for actuator subassembly procedures.
Crucial safety warnings and precautions for operating and maintaining the actuator.
Explains text formatting used for safety notices and procedural details.
Lists related bulletins and manuals for further product information.
Identifies and lists the major components of the Accutronix MX actuator.
Details product description, storage recommendations, and unit weights.
Provides guidance on initial inspection and recording of actuator identification details.
Covers recommended maintenance, lubrication, and O-ring guidelines.
Guides on removing and remounting actuator subassemblies for service.
Details the process for ordering replacement parts and subassemblies.
Step-by-step instructions for removing the actuator from torque bases.
Step-by-step instructions for removing the actuator from thrust bases.
Details the removal and remounting procedures for the motor.
Provides part lists and procedures for removing and remounting the declutch mechanism.
Instructions for removing and remounting the top-mounted handwheel.
Details removal and remounting for side-mounted handwheels without spur gear.
Instructions for removal and remounting of side-mounted handwheels with spur gear.
Procedure for converting handwheel mounting orientation.
Details parts list and removal/remounting for A1/A1E thrust bases.
Lists parts and procedures for removal and remounting of B1 torque bases.
Provides parts list and instructions for B4 baseplate removal and remounting.
Details the removal and remounting procedures for the worm shaft.
Covers removal and remounting procedures for drive sleeve assemblies for MX-05 & 10.
Covers removal and remounting procedures for drive sleeve assemblies for MX-20, 40, 85 & 140.
Explains the removal and remounting of the handwheel adapter for MX-05.
Explains the removal and remounting of handwheel adapter and worm gear components.
Details the removal and remounting procedures for clutch and clutch ring parts.
Covers the removal and remounting procedures for the ACP.
Details removal, remounting, fuse replacement, and return options for the control module.
Procedure for restoring power after installing a new control module.
Provides removal and remounting instructions for the terminal block.
Details the removal and remounting of the contactor assembly within the control module.
Covers the removal and remounting procedures for the encoder.
Details the removal and remounting procedures for the encoder drive cartridge.
Provides removal and remounting instructions for the motor lead harness.
Provides recommendations for stocking wear components, bearings, O-rings, seals, and critical parts.
Lists suggested spare parts based on duty cycle: short-term, long-term, and severe duty.
Addresses unique application requirements and strongly recommends OEM parts.
Details compliance with relevant EU directives and standards, including manufacturer and importer information.
To Next Page
