Flowserve Limitorque Accutronix MX - Drive Sleeve (MX-20 40, 85 & 140); Table 4.18 - Drive Sleeve Parts List (MX-20 & 40)

Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
STEP 4
Remount all removed subassemblies according to their remounting instructions in the following order:
1. Base plate (subassembly #11). (See Section 4.9.2.)
2. Worm shaft (subassembly #3). (See Section 4.10.2.)
3. Motor (subassembly #4). (See Section 4.1.2.)
4. Thrust base (subassembly #10) - if fitted. (See Section 4.7.2.)
4.12 Drive Sleeve (MX-20, 40, 85 & 140)
Table 4.18 – Drive Sleeve Parts List (MX-20 & 40)
Part Number Description Qty. (MX-20/40) Qty. (MX-85 & 140) Qty. (MX-85 & 140)
10:1 & 13:1 Ratio
2-1 Drive Sleeve 1 1 1
2-2 Worm Gear 1 1 1
2-3 Encoder Drive Gear 1 1 1
2-4 Ball Bearing 1 1 1
2-5 Retaining Ring 1 N/A N/A
2-6 Drive Sleeve Key 1 1 1
2-7 Spacer N/A N/A 3
2-8 Ball Bearing N/A N/A 2
2-9 Retaining Ring N/A N/A 1
Figure 4.19 – MX-20 & 40 Drive Sleeve Figure 4.20 – MX-85 & 140
10 & 13 to 1 ratio
4-44
Flow Control Division
Limitorque Actuation Systems
Mechanical Assemblies
2-1
2-2
2-3
2-4
2-5
2-6
DRIVE SLEEVE ASSEMBLY
WITH 10 AND 13 TO 1
WORM GEAR RATIO.
FIG. 4.13.B
SCALE = .25
2-4
2-9
2-8
2-1
2-8
2-3
2-7
2-7
2-7
2-2
2-6