Flowserve Limitorque Accutronix MX - Worm Shaft Assembly

Mechanical Assemblies
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
STEP 4
NOTE: (MX-20 only) Match outer bosses of baseplate with outer
bosses of actuator housing before mounting baseplate assembly.
NOTE: (MX-85 & 140) Match mounting holes in baseplate to housing
taps. Baseplate and housing has one hole/tap that is not equally
spaced.
Carefully push the baseplate assembly onto the end of the drive
sleeve, ensuring that the quad ring or seal (#11-3) is not damaged.
Align the mounting holes and secure the baseplate with the screws
(#11-5).
4.10 Worm Shaft (MX-05, 10, 20, 40, 85 & 140)
Table 4.16 – Worm Shaft Parts List (MX-05, 10, 20, 40, 85 & 140)
Part Number Description Qty. (MX-05, 10, 20 & 40) Qty. (MX-85 & 140)
3-1 Worm 1 1
3-2 Worm Shaft Cap 1 1
3-3 Ball Bearing 1 1
3-4 Ball Bearing 1 2
3-5 Ball Bearing 1 N/A
3-6 Oil Seal 1 1
3-7 O-Ring 1 1
3-8 Pin 1 2
3-9 Socket Head Cap Screw 4 4
Figure 4.17 – Worm Shaft (MX-05, 10, 20, & 40)
4-39
Flow Control Division
Limitorque Actuation Systems
4
3-5
3-1
3-2
3-4 (MX-05, 20 & 40)
3-5 (MX-10)
3-6
3-7
3-8
3-9
3-3