Flowserve Limitorque Accutronix MX - Converting Handwheel Type; Handwheel Adapter (MX-05)

Mechanical Assemblies
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
4.6 Converting Top-Mounted Handwheel to Side-Mounted
Handwheel (MX-10, 20, & 40)
4.6.1 Removing Top-Mounted Handwheel
STEP 1
a WARNING
Potential to operate while dangerous mechanical parts are
exposed during subassembly removal. To prevent injury, turn off all power
sources to actuator before removing side-mounted and top-mounted
handwheel assembly. Power sources may include: main power or control
power.
Drain oil from actuator using the lowest of 3 plugs in your application
mounting orientation.
NOTE: Oil removal is not necessary if actuator is mounted
on valve or other device with the drive sleeve in a vertical position.
STEP 2
Remove top-mounted handwheel assembly (#1) and handwheel
adapter assembly (#12) using disassembly instructions detailed in
Sections 4.3.1 and 4.13.1 respectively.
4-27
Flow Control Division
Limitorque Actuation Systems
1
2
Oil plug drain
12