Electronic Assemblies
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
5.2.1 Removal
STEP 1
a WARNING
Hazardous Voltage! Turn off all power sources to actuator
before removing control module assembly. Power sources may include main
power or control power.
CAUTION Potential to cause electrostatic damage to electronic
components. Before handling electronic components, ensure that you are
discharged of static electricity by briefly touching a grounded metal object.
If the I/O option board is installed, disconnect wire harness plug P3
and P4.
STEP 2
If DDC board is installed, disconnect wire harness plug P2.
STEP 3
Disconnect wire harness plug P1 and P4 from the main processor
board.
5-5
Flow Control Division
Limitorque Actuation Systems
1
2
3
P3
P4
P2
P1
P4
a
To Next Page
Loading...
