Flowserve Limitorque Accutronix MX - Handwheel Adapter;Worm Gear Assembly

Mechanical Assemblies
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
Table 4.11 – Type A1 Thrust Base Parts List (MX-10, 20, 40 & 140)
Part No. Description Qty. (MX-10) Qty. (MX-20) Qty. (MX-40) Qty. (MX-140)
10-1 Thrust Base Housing 1 1 1 1
10-2 Thrust Pilot (Threaded on MX-40) 1 1 1 1
10-3 Thrust Nut (A1 or A1E) 1 1 1 1
10-6 Socket Head Cap Screw 1 1 N/A 2
10-7 Washer 1 1 N/A 2
10-8 Pipe Plug 1 N/A N/A N/A
10-10 Socket Head Cap Screw 4 4 4 1
10-10 Hex Head Cap Screws N/A N/A N/A 2
10-11 Grease Fitting 1 1 1 4
10-12 Thrust Bearing 2 2 2 2
10-13 Thrust Washer 4 4 4 1
10-14 Quad Ring 1 1 N/A N/A
10-15 O-Ring 1 1 1 N/A
10-16 Quad Ring 1 1 1 8
10-17 Gasket N/A N/A 1 1
Figure 4.11 – Type A1 Thrust Base (MX-10, 20, & 40)
CAUTION
: The MX-10 through 40 A1/A1E thrust base contains lubrication. Ensure that a quality Calcium-based lubri-
cant with EP additive is replaced when reassembling a thrust base.
4-31
Flow Control Division
Limitorque Actuation Systems
10-2
10-15
10-13
10-3
10-6
10-7
10-16
10-12
10-21
10-13
10-10
10-1
10-11
10-17
MX-40 gasket
and quad ring
not shown
10-14