Mechanical Assemblies
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
STEP 4
Remove clutch ring (#1-37).
MX-85 & 140 (removing clutch ring assembly)
While pulling up on clutch ring end with socket head cap screw
(#15-9), rotate latch 90˚and slide clutch ring over drive sleeve
and out of housing.
4.15.2 Remounting
a WARNING Potential to operate while dangerous mechanical parts are exposed during subassembly removal. To
prevent injury, turn off all power sources to actuator before removing clutch and clutch ring components. Power
sources may include: main power or control power.
STEP 5a (MX-20 & 40 only)
Remounting clutch ring
Fit the clutch ring (#1-37) over the drive sleeve with the tangs (forked
protrusion) facing down. Seat tangs over declutch cam (see Figures 5a
and 5a1 at right). See warning note in Section 4.14.2, Step 8.
4-61
Flow Control Division
Limitorque Actuation Systems
Declutch cam
Tangs
5a1
5a2
5a
Clutch tangs
on clutch
ring (1-37)
4
1-37
To Next Page
Loading...
