Flowserve MASTER STATION IV EEP-SN4001 - Page 4

Limitorque
®
Master Station IV EEP-SN4001 FCD LMENIM5010-00-AQ – 03/19
4
Figures
Figure 1.1 - Introduction 7
Figure 1.2 - Enter User Name 7
Figure 1.3 - Login 7
Figure 1.4 - Main Menu 8
Figure 2.1 – MSIV Functional Flowchart 11
Figure 4.1 – MSIV Rear Panel Electrical Connections 14
Figure 4.2 – Debug Port Connection: DB9 Male 15
Figure 4.3 – DCS Serial Port Connection: DB9 Female 16
Figure 4.4 – Modbus Redundant Loop Topology 18
Figure 4.5 – Hot Standby Redundant Wiring Diagram. Refer to Fig. 4.4 for cable shield wiring
(applies to both Active and Standby Modules) 19
Figure 5.1 – The Main Menu Screen 20
Figure 5.2 – System Status 21
Figure 5.3 – Network Status 21
Figure 5.4 – MOV Status Screen 22
Figure 5.5 – MSIV Module Status 22
Figure 5.6 – MOV Data 23
Figure 6.1 – System Control Menua 24
Figure 6.2 – MOV Control Menu 25
Figure 6.3 – Control Relays 25
Figure 6.4 – Emergency Shutdown 26
Figure 6.5 – Emergency Shutdown in Progress 26
Figure 6.6 – Emergency Shutdown Termination 27
Figure 7.1 – System Configuration Menu 28
Figure 7.2 – System Settings Menu 29
Figure 7.3 – Software Version Information 30
Figure 7.4 – Language Selection Menu 30
Figure 7.5 – System Clock Settings 31
Figure 7.6 – Time Zone Settings 31
Figure 7.7 – Screen Saver Settings 32
Figure 7.8 – Redundant Configuration Menu 32
Figure 7.9 – Configuration Transfer Lockout 33
Figure 7.10 – MOV Tag List 33
Figure 7.11 – User Administration Menu 34
Figure 7.12 – Delete User Menu 34
Figure 7.13 – User Settings Menu 35
Figure 7.14 – Change Password Menu 35
Figure 7.15 – DCS Configuration Menu 36
Figure 7.16 – Configure DCS Serial Port 36
Figure 7.17 – Configure DCS Ethernet Port 37
Figure 7.18 – Configure DCS Data Table Menu 37
Figure 7.19 – FC 02 Read Input Status 38
Figure 7.20 – FC 03 Read Holding Registers Menu 41