Flowserve MASTER STATION IV EEP-SN4001 User Manual

Limitorque
®
Master StationI V EEP-SN4001 FCD LMENIM5010-00-AQ – 03/19
9
flowserve.com
1.5 System Technical Data
1. Power supply
1.1. Nominal: 24VDC to 48VDC (+/- 10%).
1.2. Absolute minimum: 21.6VDC.
1.3. Absolute maximum: 52.8VDC.
1.4. Maximum current draw is 2.0 amps.
2. Operating environment
2.1. It is recommended to install and operate the MSIV in an indoor, climate-controlled environment,
ideally in temperature range of 10 Celsius to 30 Celsius.
2.2. Absolute minimum operating ambient temperature: 0 degrees Celsius
2.3. Absolute maximum operating ambient temperature: 40 degrees Celsius
2.4. Humidity: maximum 85% RH non-condensing
3. Storage
3.1. Store the MSIV in a cool, dry area, out of direct sunlight.
3.2. Minimum storage temperature: -20 degrees Celsius
3.3. Maximum storage temperature: 60 degrees Celsius
3.4. Humidity: maximum 95% RH non-condensing
4. Human machine interface
4.1. 6.5” diagonal touch panel LCD
4.2. 640x480 resolution
4.3. Multiple language support: English, Spanish, and Chinese
5. Communication Protocols
5.1. MSIV to Field Units
5.1.1. Modbus RTU
5.1.1.1. EIA-485 (RS-485) physical layer
5.1.1.2. Bi-directional redundant loop or multi-drop network topologies
5.1.1.3. Maximum communication rate of 38.4 Kbaud
5.2. MSIV to DCS
5.2.1. Modbus RTU
5.2.1.1. TIA-232 (RS-232) physical layer
5.2.1.2. If RS-485 or RS-422 physical layers are required, an external converter can be specified.
5.2.1.3. Maximum communication rate of 115.2 Kbaud
5.2.2. Modbus TCP/IP
5.2.2.1. 10/100Mbit ethernet physical layer
6. System Redundancy
6.1. A completely modular, redundant system can be setup using two EEP-SN4001 modules.
6.2. Wire the modules in parallel to the same Modbus RTU actuator network and configure one module as
Active and one as Standby.
6.3. The Standby module will monitor network communications and if the Active module fails, the Standby
module will become active and take over the actuator network communications.
7. Electromagnetic Compatibility (EMC) Compliance
7.1. EN 61326-1:2013
7.2. EN 55011:2009+A1(2010) Class A
7.3. EN 61000-4-2:2009
7.4. EN 61000-4-3:2006+A1(2008)+A2(2010)
7.5. EN 61000-4-4:2004+A1(2010)
7.6. EN 61000-4-5:2006
7.7. EN 61000-4-6:2009
7.8. EN 61000-4-8:2010
7.9. EN 61000-4-11:2004

Flowserve MASTER STATION IV EEP-SN4001 Specifications

General

Brand	Flowserve
Model	MASTER STATION IV EEP-SN4001
Category	Control Unit
Language	English