5520A
Operators Manual
5-12
4. Negotiate the softkey selections shown below to select the HOST serial port
parameters to match the PC COM parameters. (Individual softkey functions are
discussed in Chapter 3, “Features.”) If operating the port with a computer program
instead of individual commands from a terminal, select Remote I/F comp.
nn122f.eps
5. Press P (not E ) several times until the message STORE
CHANGES/DISCARD CHANGES appears or, if there were no changes, the reset
display. If you select STORE CHANGES, the serial and host port setting are saved
in the instrument non-volatile memory.
To Next Page
Loading...
