Preparing for Operation
Introduction
2
2-3
Warning
The 5520A Calibrator can supply lethal voltages. To avoid
shock hazard, read this section before operating the calibrator.
2-1. Introduction
This chapter provides instructions for unpacking and installing the 5520A, selecting the
line voltage, replacing the fuse, and connecting to line power. Instructions for cable
connections other than line power can be found in the following chapters:
• UUT (Unit Under Test) connections: Chapter 4, “Front Panel Operation”
• IEEE-488 parallel interface connection: Chapter 5, “Remote Operation”
• RS-232C serial interface connection: Chapter 5, “Remote Operation”
2-2. Unpacking and Inspection
The calibrator is shipped in a container designed to prevent damage during shipping.
Inspect the calibrator carefully for damage and immediately report any damage to the
shipper. Instructions for inspection and claims are included in the shipping container.
When you unpack the calibrator, check for all the standard equipment listed in Table 2-1
and check the shipping order for any additional items ordered. Refer to Chapter 9,
“Accessories” for more information. Report any shortage to the place of purchase or to
the nearest Fluke Service Center (see “Service Information” in this section). A
performance test is provided in Chapter 7, “Maintenance.”
If reshipping the calibrator, use the original container. If it is not available, you can order
a new container from Fluke by indicating the Calibrator's model and serial number.
Table 2-1. Standard Equipment
Item Model or Part Number
Calibrator 5520A
Line Power Cord See Table 2-2 and Figure 2-2
5520A Operators Manual
(English) 688739
5520A Operators Guide
(English) 688754
5520A Operators Guide
(French) 688751
5520A Operators Guide
(Italian) 690511
5520A Operators Guide
(German) 688762
5520A Operators Guide
(Spanish) 688769
5520A Operators Guide
(Japanese) 688770
5520A Operators Guide
(Simplified Chinese) 688777
5520A Programmers Guide
(English) 688744
Certificate of Calibration −
To Next Page
Loading...
