Fluke 5520A - 6-89. Time Marker Function Specifications; 6-90. Wave Generator Specifications

Remote Commands
Command Summary by Function
6
6-5
6-6. Oscilloscope Commands
(See Chapter 8 for usage information.)
OL_TRIP? Returns the detected state of scope overload protection.
OUT_IMP Sets the output impedance of the SCOPE BNC.
OUT_IMP? Returns the output impedance of the SCOPE BNC.
RANGE Sets the Calibrator range when in OVERLD, PULSE, or MEASZ scope modes.
SCOPE Sets the calibrator output to an oscilloscope mode.
SCOPE? Returns the present oscilloscope mode.
TDPULSE Activates or deacvitates the tunnel diode pulser drive for the -SC600 EDGE mode.
TDPULSE? Returns whether the tunnel diode pulser drive for the -SC600 EDGE mode is
active.
TLIMIT Sets the time limit for -SC600 OVERLD mode to stay in operate.
TLIMIT? Returns the time limit for -SC600 OVERLD mode to stay in operate.
TLIMIT_D Sets the power-up and reset default for the time limit for -SC600 OVERLD mode to
stay in operate.
TLIMIT_D? Returns the power-up and reset default for the time limit for -SC600 OVERLD
mode to stay in operate.
TMWAVE Selects the waveform for MARKER mode.
TMWAVE? Returns the timemark waveform setting for MARKER mode.
TRIG Sets the frequency of the signal at the TRIG OUT BNC.
TRIG? Returns the frequency of the signal at the TRIG OUT BNC.
VAL? Returns the last thermocouple, pressure, or, for the -SC600, impedance
measurement value.
VIDEOFMT Selects the format for VIDEO mode.
VIDEOFMT? Returns the VIDEO mode format.
VIDEOMARK Sets the VIDEO mode line marker location.
VIDEOMARK? Returns the VIDEO mode line marker location.
ZERO_MEAS Zeros the pressure module or sets the zero offset for capacitance measurement
using the -SC600.
ZERO_MEAS? Returns the zero offset for the pressure module or capacitance measurement
using the -SC600.
6-7. Output Commands
CFREQ? Returns the optimum frequency value for stimulus for capacitance modes.
DBMZ Sets the impedance used for dBm outputs (ac volts).
DBMZ? Returns the impedance used for dBm outputs (ac volts).
DC_OFFSET Applies a dc offset to an ac output voltage.
DC_OFFSET? Returns the dc offset voltage.