Fluke 5520A - Host Port Commands; UUT Port Commands

Remote Commands
Command Summary by Function
6
6-7
6-8. Pressure Measurement Commands
DAMPEN Activates or deactivates dampening (averaging) of pressure readings.
DAMPEN? Returns whether dampening (averaging) of pressure readings is active.
PRES? Queries the attached pressure module for its model and serial number.
PRES_MEAS Changes the operating mode to pressure measurement.
VAL? Returns the last thermocouple, pressure, or, for the -SC600, impedance
measurement value.
ZERO_MEAS Zeros the pressure module or sets the zero offset for capacitance measurement
using the -SC600.
ZERO_MEAS? Returns the zero offset for the pressure module or capacitance measurement using
the -SC600.
6-9. RS-232 Host Port Commands
LOCAL Puts the Calibrator into the local state.
LOCKOUT Puts the Calibrator into the lockout state. This command duplicates the IEEE-488
LLO (Local Lockout) message.
REMOTE Puts the Calibrator into the remote state. This command duplicates the IEEE-488
REN (Remote Enable) message.
SPLSTR Sets the serial remote mode Serial Poll response string.
SPLSTR? Returns the string programmed for serial remote mode Serial Poll responses.
SRQSTR Sets the serial remote mode SRQ (Service Request) response (up to 40 characters).
SRQSTR? Returns the string programmed for Serial Mode SRQ response.
UUT_RECVB? Returns binary data from the UUT serial port as integers.
UUT_SENDB Sends binary data to the UUT serial port as integers.
^P (<cntl>p) Control-P character prints the serial poll string. (See SPLSTR for string format.)
^C (<cntl>c) Control-C character clears the device.
^T (<cntl>t) Control-T character executes a group trigger.
6-10. RS-232 UUT Port Commands
UUT_FLUSH Flush the UUT receive buffer.
UUT_RECV? Returns data from the UUT serial port.
UUT_RECVB? Returns binary data as integers from the UUT serial port.
UUT_SEND Sends a string to the UUT serial port.
UUT_SET Sets the UUT serial port communication parameters and saves them in nonvolatile
memory.
UUT_SET? Returns the UUT serial port communication parameters contained in nonvolatile
memory.