5520A
Operators Manual
5-32
5-35. Commands for IEEE-488 Only
The command graphic
IEEE-488
x
indicates commands that are used for the IEEE-
488 interface. This is all the commands, except for those used for RS-232 operations.
(See “Commands for RS-232 Only.”) All commands are transferred over the IEEE-488
as data, except for the commands LOCAL, REMOTE, and LOCKOUT, which are
implemented per IEEE Standards as messages (see Table 5-7).
Table 5-7. Commands for IEEE-488 Only
IEEE-488 Message [1] Command Representation
GTL LOCAL command
GTR REMOTE command
LLO LOCKOUT command
SDC, DCL Clear the device
GET Execute a group trigger
SPE, SPD Print the serial poll string
[1] See “How IEEE-488 Operates” later in this chapter.
To Next Page
Loading...
