Fluke 5520A - Page 410

5520A
Operators Manual
E-4
547 (DDE: ) Can’t set output imp. now
548 (DDE:FR ) Compensation is now OFF
549 (DDE: ) Period must be >= 0
550 (DDE: ) A report is already printing
551 (DDE: ) ScopeCal option not installed
552 (DDE: ) Not a ScopeCal function
553 (DDE: ) Can’t set marker shape now
554 (DDE: ) Can’t set video parameter now
555 (DDE: ) Marker location out of range
556 (DDE: ) Pulse width must be 1 - 255
557 (DDE: ) Can’t set range directly now
558 (DDE: ) Not a range for this function
559 (DDE: ) Can’t set TD pulse now
560 (DDE: ) ZERO_MEAS only for C or PRES meas
561 (DDE:FR ) That requires a -SC option
562 (DDE:FR ) That requires a -SC600 option
563 (DDE: ) Time limit must be 1s-60s
564 (DDE: ) Can’t set ref. phase now
565 (DDE: ) ZERO_MEAS reading not valid
566 (DDE: ) Can’t set dampen now
567 (DDE: ) Can’t turn EXGRD on now
600 (DDE:FR D) Outguard watchdog timeout
601 (DDE:FR ) Power-up RAM test failed
602 (DDE:FR ) Power-up GPIB test failed
700 (DDE: R ) Saving to NV memory failed
701 (DDE: R ) NV memory invalid
702 DDE: R ) NV invalid so default loaded
703 (DDE: R ) NV obsolete so default loaded
800 (DDE:FR ) Serial parity error %s
801 (DDE:FR ) Serial framing error %s
802 (DDE:FR ) Serial overrun error %s
803 (DDE:FR ) Serial characters dropped %s
900 (DDE:FR ) Report timeout - aborted
1000 (DDE:FR ) Sequence failed during diag
1001 (DDE:FR ) Guard xing link diag fail
1002 (DDE:FR ) Inguard bus r/w diag fail
1003 (DDE:FR ) A6 A/D comm fault
1004 (DDE:FR ) A6 A/D or DAC fault
1005 (DDE:FR ) A6 DAC fine channel fault
1006 (DDE:FR ) A6 DCI loop fault
1007 (DDE:FR ) A6 ACI loop fault
1008 (DDE:FR ) A6 TC fault
1009 (DDE:FR ) A6 DCV loop fault
1010 (DDE:FR ) A6 ACV loop fault
1011 (DDE:FR ) A6 33 mV divider fault
1012 (DDE:FR ) A6 330 mV DC fault