EasyManua.ls Logo

Fluke 6080A - Section 1 Introduction and Specifications; INTRODUCTION 1-1.; UNPACKING THE SIGNAL GENERATOR 1-2.

Fluke 6080A
296 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 1
Introduction and Specifications
INTRODUCTION 1-1.
The 6080A/AN Synthesized RF Signal Generator (also referred to throughout as the
"signal generator") is a fully programmable, precision, synthesized signal generator.
The 6080A/AN is designed for applications that require good modulation, frequency
accuracy, and output level performance with excellent spectral purity. The signal
generator is well suited for testing a wide variety of RF components and systems
including filters, amplifiers, mixers, and radios, particularly off-channel radio testing.
Specifications of the 6080A/AN are provided at the end of this section. The salient
features of the 6080A/AN are as follows:
• RF frequency range of 0.5 MHz to 1024 MHz in 1 Hz steps
• RF level range of +13 to -137 dBm in 0.1 dB steps
• Internal and External Modulation: AM, FM, and Pulse
• Internal 10 Hz to 100 kHz Synthesized Sine Wave Modulation Oscillator
• Fifty Storable and Recallable Memory Locations
• Standard IEEE-488 (GPIB) Interface, complying with ANSI/IEEE Standards
488.1-1987 and 488.2-1987
• Closed-case calibration capabilities for Frequency Reference, AM, FM, and
Level.
UNPACKING THE SIGNAL GENERATOR 1-2.
The shipping container should include a 6080A/AN Synthesized RF Signal generator,
an Operator Manual, a Service Manual, a line power cord and two BNC dust caps.
Accessories ordered for the signal generator are shipped in a separate container.
1-1

Table of Contents