REPLACEMENT PARTS
INTRODUCTION 7-1.
Section 7 contains an illustrated list of replaceable parts for the 6080A/AN
Synthesized Signal Generator. Parts are listed alphanumerically by assembly.
The part lists include the following information:
1. Reference Designation
2. Description of each part
3. Fluke Stock Number
4. Federal Supply Code for Manufacturers.
A list of part manufacturers, arranged numerically by Federal Supply Code, is
provided at the end of Section 7.
5. Manufacturer's part number.
6. Total Quantity of components per assembly.
7. Recommended Quantity.
This entry indicates the recommended number of spare parts necessary to support
one to five instruments for a period of 2 years. This list presumes an availability of
common electronic parts at the maintenance site. For maintenance for 1 year or
more at an isolated site, it is recommended that at least one of each assembly in the
instrument be stocked.
HOW TO OBTAIN PARTS 7-2.
Components may be ordered directly from the manufacturer by using the manufactur-
er's part number, or from John Fluke Mfg. Co. (or its authorized representative) by
using the Fluke stock number.
In the event the part you order has been replaced by a new or improved part, the
replacement will be accompanied by an explanatory note and, if necessary, installation
instructions.
To ensure prompt and efficient handling of your order, include the following
information.
1. Quantity.
2. Fluke Stock Number.
3. Description.
4. Reference Designation.
5. Printed Circuit Board Part Number and Revision Letter.
6. Instrument Model and Serial Number.
7-2
To Next Page
Loading...
