INTRODUCTION AND SPECIFICATIONS
SAFETY 1-3.
This manual contains information, warnings, and cautions that should be followed to
ensure safe operation and to maintain the generator in a safe condition.
The signal generator is designed primarily for indoor use and may be operated in
temperatures from 0 to 50° C without degradation of its safety.
WARNING
TO AVOID ELECTRIC SHOCK, USE A POWER CORD THAT HAS A
THREE-PRONG PLUG. IF THE PROPER POWER CORD IS NOT USED, THE
6080A/AN CASE CAN DEVELOP AN ELECTRICAL POTENTIAL ABOVE
EARTH GROUND.
WARNING
PIVOTING MODULE INSTRUCTIONS
IF NECESSARY DURING REPAIRS, PIVOT THE TOP (SYNTHESIZER)
MODULE UP TO ALLOW ACCESS TO ALL PARTS OF THE SIGNAL
GENERATOR THE MODULE IS HEAVY AND CARE SHOULD BE
EXERCISED. THE GAS STRUT IS PROVIDED FOR PROTECTION. CHECK
THE CORRECT OPERATION OF THE GAS STRUT BY NOTING THE
RESISTANCE TO RAPID CLOSING OF THE MODULE WHILE YOU FIRMLY
GRASP THE MODULE BY THE HANDLE.
OPENING AND CLOSING INSTRUCTIONS ARE GIVEN BELOW AND ARE
REPEATED ON THE DECAL ON THE TOP FRONT OF THE SYNTHESIZER
MODULE.
RAISING THE MODULE:
1. REMOVE THREE HOLD-DOWN SCREWS LOCATED ON THE SIDE
RAILS.
2. GRASP THE HANDLE AND LIFT UP.
3. LOCK IN THE UP POSITION BY INSTALLING ONE SCREW IN THE PROTRUDING
BOSS ON EACH SIDE RAIL.
LOWERING THE MODULE:
1. SUPPORT IN THE UP POSITION AND REMOVE TWO LOCK UP SCREWS.
2. GRASP THE HANDLE AND LOWER THE MODULE KEEPING YOUR HANDS
CLEAR.
3. LOCK IN THE DOWN POSITION BY REINSTALLING THE THREE HOLD-DOWN
SCREWS.
1-2
To Next Page
Loading...
