5 USE STATIC SHIELDING CONTAINERS FOR
HANDLING AND TRANSPORT
6 DO NOT SLIDE S S DEVICES OVER
ANY SURFACE
7. AVOID PLASTIC. VINYL AND STYROFOAM®
IN WORK AREA
8 WHEN REMOVING PLUG-IN ASSEMBLIES,
HANDLE ONLY BY NON-CONDUCTIVE
EDGES AND NEVER TOUCH OPEN EDGE
CONNECTOR EXCEPT AT STATIC-FREE
WORK STATION. PLACING SHORTING
STRIPS ON EDGE CONNECTOR HELPS TO
PROTECT INSTALLED SS DEVICES.
9 HANDLE S S DEVICES ONLY AT A
STATIC-FREE WORK STATION
10 ONLY ANTI-STATIC TYPE SOLDER-
SUCKERS SHOULD BE USED
11 ONLY GROUNDED TIP SOLDERING
IRONS SHOULD BE USED
A complete line of static shielding bags and acces-
sories is available from Fluke Parts Department,
Telephone 800-526-4731 or write to:
JOHN FLUKE MFG CO, INC
PARTS DEPT. M/S 86
9028 EVERGREEN WAY
EVERETT, WA 98204
PORTIONS REPRINTED
WITH PERMISSION FROM TEKTRONIX, INC
AND GENERAL DYNAMICS, POMONA DIV
* Dow Chemical
Page 2 of 2
J0089D-07U8604/SE EN Litho in U S A
Rev 1 MAR 86
To Next Page
Loading...
