ACCESS PROCEDURES
NOTE
When reinstalling C1, be certain to put it between J1 on the A22 Delay
Cable assembly and J9 on the A2 Coarse Loop. J2 on A22 and J10 on the
A2 PCA are not used.
4. Remove the four #6 screws holding the A25 Discriminator PCA. Do not remove
the screws holding the clamp that attaches the delay line itself to the PCA.
5. Remove the two #6 screws holding the lower delay cable retainer.
6. Remove the two #6 screws holding the upper delay cable retainer, which holds the
A26 Delay Cable PCA in place. Do not remove the screws holding the clamp that
attaches the delay line itself to the PCA; do not disconnect the SMA connector on
the semi-rigid trim cable.
7. Remove the A22 Delay Line assembly.
5-9/5-10
To Next Page
Loading...
