Endurance
®
Series
Users Manual, Rev. 2.0, Jun 2020
124
Command Answer
“017?E” “017E0.950” // asking one sensor on address 17
“017XA=024” “017XA024” // setting of a new address
“024?E” “024E0.950” // asking same sensor now on address 24
If a command is transferred, starting with the 3-digit number 000, all units (with addresses from 001 to 032)
connected will get this command – without to send an answer.
Command Answer
“024?E” “024E0.950”
“000E=0.5” will be executed from all sensors, no answer
“024?E” “024E0.500”
“012?E” “012E0.500”
To Next Page
Loading...
