Endurance
®
Series
Users Manual, Rev. 2.0, Jun 2020
48
ATTENUATION FAILSAFE
allows to set the attenuation threshold for the failsafe warning EAAA. Range is from 0 to 95% of attenuation.
LASER/LED/CAMERA
For the pointing device (LASER, LED, CAMERA) you can toggle between the following modes:
• ON – switches the pointing device permanently to ON
• OFF – switches the pointing device permanently to OFF
• TRIGGER LEVEL – switches the pointing device based on the signal level on the trigger input
• TRIGGER EDGE – switches the pointing device based on the signal edge on the trigger input
• FLASH – the pointing device flashes (not for CAMERA)
FACTORY DEFAULT
parameters of the sensor back to factory default values, see section 14.9 Command List, page 125.
KEY -ENTER-
shows the LOCKED / UNLOCKED status to avoid unintended user control interactions if the sensor communicates
digitally.
To Next Page
Loading...
