FOR-A MFR-6000 - Page 65

65
MFR-8SDOEX
SDI Output Card: 75 ohm, BNC x 8 (16 cards Max.)
Complies with the following standards (75Ω BNC) (Auto reclocking)
- SMPTE424M (3G-SDI)
- SMPTE292M (HD-SDI)
- SMPTE259M (SD-SDI)
- DVB-ASI
Cable Equalization
3G/HD-SDI: 100m (5C-FB cable)
SD-SDI: 200m (5C-2V cable)
MFR-2SDOGB
SDI Output Card
BNC x 2 (12G-SDI or 3G-SDI )
BNC x 6 (3G-SDI)
Complies with the following standards (75Ω BNC)
SMPTE ST 2082-10 (12G-SDI)
SMPTE ST 425-5 (Quad Link 3G-SDI)
I/O delay selection
Delay (H) (0.3H-1H), 1 frame, 1 frame+ Delay (H)
Reference Input
BB: 0.429 Vp-p (NTSC)/0.45 Vp-p (PAL) or Tri-level Sync: 0.6 Vp-p
75Ω BNC x 2, loop-through (Terminate with 75Ω terminator, it
unused.)
Interfaces
MFR-LAN
10/100 BASE-TX, RJ-45 x 2
(For connecting up to 128 RU/GPI units.)
(Second LAN port used in redundant CPU configuration)
PC-LAN
10/100/1000 BASE-T, RJ-45 x 2 (for PC operation)
(Second LAN port used in redundant CPU configuration)
SERIAL
RS-232C/RS-422 (Internal switch), 9-pin D-sub (male) x 1
ALARM
9-pin D-sub 9 (female) x1
(Input: Reset, Output: Power, Fan Alarm)
Temperature
0ºC to 40ºC
Humidity
30% to 85% (no condensation)
Power
100 VAC to 240 VAC ±10%, 50/60Hz IN x 2
Consumption
SDI 144 x 144, Dual CPU/Redundant Power Unit (Maximum
Configuration)
100 V AC to 120 V AC: 1100 VA (1067 W)
220 V AC to 240 V AC: 1078 VA (689 W)
Dimensions
480 (W) x 576 (H) x 400 (D) mm, EIA 13 RU
Weight
73.2 kg (Including all options)
Consumables
Power supply unit: Replace every 5 years
FAN1-3(P-1619): Replace every 4 years.
FAN4-5(P-1620): Replace every 4 years.
FAN6-7(P-1621): Replace every 4 years.