MANTIS User's Guide | Chapter 9: Dispensing With the MANTIS
Advanced Options
This section covers the following topics:
● Application Settings
● Arms Settings
● Dispense Settings
● Dispense Summary Settings
● Hand Settings
● Integration Service (IS) Settings
● Manual Arms Control Settings
● RFID Settings
● Security Settings
● Stage Settings
● Support Settings
Unless you are completely confident about the changes you are about to make, you
should not edit the following settings without guidance from FORMULATRIX support.
If you need a simple refresher, however, use the tables in each drop-down topic below to
help you understand and configure the various options.
Application Settings
See the table below for detailed explanations of each option found in the Application area.
Arms Settings
See the table below for detailed explanations of each option found in the Arms area.
Important: These settings are for advanced users only! Doing something incorrectly
here may render your system inoperable. Consult with FORMULATRIX support if
you have any questions.
Option Default Setting Description
Show Deck
Geometry
Correction Menu
False
Set this option to True to display the Deck
Geometry Correction menu.
Option Default Setting Description
Attach Detach
Status
Disable
Set this option to Enable to enable the MANTIS
attach and detach status check. When enabled,
the air pump will be used to ensure whether the
chip is properly attached to or detached from
the MANTIS hand.
Home Stage Motors
During Picking Chip
Before and After
Determines when to home the stage motors
while picking up the chip.
To Next Page
Loading...