Fortinet Technologies Inc. Page 104 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
system time ntp
Use this command to configure the FortiVoice unit to synchronize its system time with a
network time protocol (NTP) server.
Accurate system time is required by many features of the FortiMail unit, such as log messages.
Alternatively, you can manually configure the system time of the FortiVoice unit. For details, see
“system time manual” on page 103.
Syntax
config system time ntp
set ntpserver {<address_ipv4> | <fqdn_str>}
set ntpsync {enable | disable}
set syncinterval <interval_int>
end
Variable Description Default
ntpserver
{<address_ipv4> |
<fqdn_str>}
Enter either the IP address or fully qualified domain name
(FQDN) of an NTP server.
You can add a maximum of 10 NTP servers. The
FortiVoice unit uses the first NTP server based on the
selection mechanism of the NTP protocol.
To locate a public NTP server, visit http://www.ntp.org/.
pool.ntp.org
ntpsync
{enable | disable}
Enable to synchronize the FortiVoice unit with an NTP
server, instead of manually configuring the system time.
enable
syncinterval
<interval_int>
Enter the interval in minutes between synchronizations of
the system time with the NTP server. The valid range is
from 1 to 1440 minutes.
60
To Next Page
Loading...
