Fortinet Technologies Inc. Page 123 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
factoryreset
Use this command to reset the FortiVoice unit to its default settings for the currently installed
firmware version. If you have not upgraded or downgraded the firmware, this restores factory
default settings.
Syntax
execute factoryreset
Back up your configuration before entering this command. This procedure resets all changes
that you have made to the FortiVoice unit’s configuration file and reverts the system to the
default values for the firmware version, including factory default settings for the IP addresses
of network interfaces. For information on creating a backup, see the FortiVoice Setup and
Administration Guide.
To Next Page
Loading...
