Fortinet Technologies Inc. Page 9 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
5. To confirm the configuration, enter the command to view the access settings for the
interface.
show system interface <interface_name>
The CLI displays the settings, including the management access settings, for the interface.
To connect to the CLI through the network interface, see “Connecting to the CLI using SSH”
on page 9 or “Connecting to the CLI using Telnet” on page 10.
Connecting to the CLI using SSH
Once the FortiVoice unit is configured to accept SSH connections, you can use an SSH client
on your management computer to connect to the CLI.
Secure Shell (SSH) provides both secure authentication and secure communications to the CLI.
Supported SSH protocol versions, ciphers, and bit strengths vary by whether or not you have
enabled FIPS-CC mode, but generally include SSH version 2 with AES-128, 3DES, Blowfish,
and SHA-1.
Requirements
• a FortiVoice network interface configured to accept SSH connections (see “Enabling access
to the CLI through the network (SSH or Telnet)” on page 7)
• terminal emulation software such as PuTTY
To connect to the CLI using SSH
1. On your management computer, start PuTTY.
2. In Host Name (or IP Address), type the IP address of a network interface on which you have
enabled SSH administrative access.
3. In Port, type 22.
4. From Connection type, select SSH.
5. Click Open.
The SSH client connects to the FortiVoice unit.
The SSH client may display a warning if this is the first time you are connecting to the
FortiVoice unit and its SSH key is not yet recognized by your SSH client, or if you have
previously connected to the FortiVoice unit but it used a different IP address or SSH key. If
your management computer is directly connected to the FortiVoice unit with no network
hosts between them, this is normal.
6. Click Yes to verify the fingerprint and accept the FortiVoice unit’s SSH key. You will not be
able to log in until you have accepted the key.
7. The CLI displays a login prompt.
8. Type a valid administrator account name (such as admin) and press Enter.
You can alternatively log in using an SSH key. For details, see “system admin” on page 79.
To Next Page
Loading...
