Fortinet FortiVoice 200D - Ping6-Option

Fortinet Technologies Inc. Page 130 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
ping6-option
Use this command to configure behavior of “ping6” on page 129.
Syntax
execute ping6-option data-size <bytes_int>
execute ping6-option pattern <bufferpattern_hex>
execute ping6-option repeat-count <repeat_int>
execute ping6-option source {auto | <interface_ipv4>}
execute ping6-option timeout <seconds_int>
execute ping6-option tos {default | lowcost | lowdelay | reliability
| throughput}
execute ping6-option ttl <hops_int>
execute ping6-option validate-reply {yes | no}
execute ping6-option view-settings
Variable Description Default
data-size <bytes_int> Enter datagram size in bytes.This allows you to
send out packets of different sizes for testing the
effect of packet size on the connection. If you
want to configure the pattern that will be used to
buffer small datagrams to reach this size, also
configure pattern <bufferpattern_hex>.
56
pattern <bufferpattern_hex> Enter a hexadecimal pattern, such as 00ffaabb,
to fill the optional data buffer at the end of the
ICMP packet. The size of the buffer is determined
by data-size <bytes_int>.
repeat-count <repeat_int> Enter the number of times to repeat the ping. 5
source {auto | <interface_ipv4>} Select the network interface from which the ping
is sent. Enter either auto or a FortiVoice network
interface’s IP address.
auto
timeout <seconds_int> Enter the ping response timeout in seconds. 2
tos {default | lowcost | lowdelay |
reliability | throughput}
Enter the IP type-of-service option value, either:
• default: Do not indicate. (That is, set the
TOS byte to 0.)
• lowcost: Minimize cost.
• lowdelay: Minimize delay.
• reliability: Maximize reliability.
• throughput: Maximize throughput.
default
ttl <hops_int> Enter the time-to-live (TTL) value. 64
validate-reply {yes | no} Select whether or not to validate ping replies. no
view-settings Display the current ping option settings.