Fortinet FortiVoice 200D - Pbx Feature-Access-Code

Fortinet Technologies Inc. Page 54 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
pbx feature-access-code
Use this command to configure the codes for users to use to access certain features.
By default, the FortiVoice unit has defined 14 codes for users to access certain features by
dialing the codes. You can modify its code and description, but that does not change the
mapping between the code and the feature.
For example, if you change the DISA code from the default ** to 12, dialing 12 still accesses the
DISA feature.
Syntax
config pbx feature-access-code
edit <name>
set code <string>
set description <content>
set with-parameter {enable | disable}
end
Variable Description Default
<name> Enter the feature access code name.
code <string> Enter the code for a feature.
description <content> Enter the description for the feature code.
with-parameter {enable |
disable}
Enable to allow entering further parameter for some
feature codes that require more values than codes only,
such as pickup-ext. Without the parameters, these
codes will not work.
disable