Fortinet Technologies Inc. Page 14 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
Sub-commands
Once you have connected to the CLI, you can enter commands.
Each command line consists of a command word that is usually followed by words for the
configuration data or other specific item that the command uses or affects:
get system admin
Sub-commands are available from within the scope of some commands.When you enter a
sub-command level, the command prompt changes to indicate the name of the current
command scope. For example, after entering:
config system admin
the command prompt becomes:
(admin)#
Applicable sub-commands are available to you until you exit the scope of the command, or until
you descend an additional level into another sub-command.
Curly braces { } A word or series of words that is constrained to a set of options
delimited by either vertical bars or spaces.
You must enter at least one of the options, unless the set of options
is surrounded by square brackets [ ].
Options
delimited by
vertical bars |
Mutually exclusive options. For example:
{enable | disable}
indicates that you must enter either enable or disable, but must
not enter both.
Options
delimited by
spaces
Non-mutually exclusive options. For example:
{http https ping snmp ssh telnet}
indicates that you may enter all or a subset of those options, in any
order, in a space-delimited list, such as:
ping https ssh
Note: To change the options, you must re-type the entire list. For
example, to add snmp to the previous example, you would type:
ping https snmp ssh
If the option adds to or subtracts from the existing list of options,
instead of replacing it, or if the list is comma-delimited, the exception
will be noted.
Table 1: Command syntax notation
To Next Page
Loading...
