Fortinet FortiVoice 200D - System Auto-Provisioning

Fortinet Technologies Inc. Page 82 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
system auto-provisioning
Use this command to configure the FortiVoice unit to auto-provision SIP phones on your
network. The SIP phones must support auto-provisioning using TFTP.
For more information about auto provisioning, see the FortiVoice Setup and Administration
Guide.
Syntax
config system auto-provisioning
set config-unassigned-phone {enable | disable}
set ntp-interface {port1 | port2 | port3 | port4}
set ntp-server <ip_string>
set ntp-server-option {bind-to-interface | static-ip}
set phone-configure-pin <string>
set sip-interface {port1 | port2 | port3 | port4}
set sip-server <ip_string>
set sip-server-option {bind-to-interface | static-ip}
set status {enable | disable}
set tftp-interface {port1 | port2 | port3 | port4}
set tftp-server <ip_string>
set tftp-server-option {bind-to-interface | static-ip}
end
Variable Description Default
config-unassigned-phone
{enable | disable}
Enable to generate phone configuration files for the
supported unassigned SIP phones.
With this option selected, once a supported SIP phone
connects to the FortiVoice unit and is auto-discovered,
the FortiVoice unit assigns an IP address to the phone
and sends the basic PBX setup information to it.
enable
ntp-interface {port1 |
port2 | port3 | port4}
If you enter bind-to-interface for ntp-server-option
{bind-to-interface | static-ip}, enter the interface for the
NTP server. The SIP phones connect to this server to
sychronize time.
port1
ntp-server <ip_string> If you enter static-ip for ntp-server-option {bind-to-
interface | static-ip}, enter the current public IP address
or public domain name of the server. The SIP phones
connect to this server to sychronize time.
ntp-server-option {bind-
to-interface | static-ip}
Enter the option for the SIP phones to connect to the
NTP server to sychronize time.
static-ip
phone-configure-pin
<string>
Enter a password to be used by a FortiFone that
connects to the FortiVoice unit to set mobile extension
number.
sip-interface {port1 |
port2 | port3 | port4}
If you enter bind-to-interface for sip-server-option
{bind-to-interface | static-ip}, enter the interface for the
server. The SIP phones connect to this server to register.