Fortinet FortiVoice 200D - Dialplan DID-Mapping

Fortinet Technologies Inc. Page 27 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
dialplan did-mapping
Use this command to configure how to map Direct Inward Dialing (DID) numbers.
Local phone companies offer DID service to provide a block of telephone numbers for calling
into an company’s PBX system over limited rented physical lines (also called "trunk lines").
Depending on the phone numbers you rent, some workstations may not get DID numbers.
Instead, they have extensions. In this case, you can map a DID number to the extensions based
on the calling numbers.
Syntax
config dialplan did-mapping
edit <name>
config mapping
edit <No.>
set caller-id-pattern <string>
set did <string>
set extension <string>
set option {inbound | outbound}
set fallback-action {auto-attendant | dial-extension | dial-
operator | dial-voicemail | hang-up }
set incoming-trunk <name>
set status {enable | disable}
end
Variable Description Default
<name> Enter a name for the DID setting.
<No.> Enter a record number for the DID mapping.
caller-id-pattern <string> Enter the caller’s phone number in the Value field.
You can add multiple calling numbers.
Only these callers will reach the mapped extension when
they dial the DID number.
did <string> Enter the DID number that you want to map to an
extension.
extension <string> Enter the extension that you want to map to the DID
number.
option {inbound |
outbound}
Enter Inbound to direct incoming calls to the extension
through the mapped DID.
Enter Outbound to send the DID numbers of the
extensions mapped to the DID with outgoing calls so
that the DID numbers can display on the called phones.
Select how the calling numbers match the caller ID
pattern.
Currently, only the equivalent numbers can reach the
mapped extensions when they dial the DID number.
inbound
extension <string> If you select dial-extension or dial voicemail
for fallback-action, enter the extension number.