Fortinet FortiVoice 200D - Ping-Option

Fortinet Technologies Inc. Page 128 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
ping-option
Use this command to configure behavior of “ping” on page 127.
Syntax
execute ping-option data-size <bytes_int>
execute ping-option df-bit {yes | no}
execute ping-option pattern <bufferpattern_hex>
execute ping-option repeat-count <repeat_int>
execute ping-option source {auto | <interface_ipv4>}
execute ping-option timeout <seconds_int>
execute ping-option tos {default | lowcost | lowdelay | reliability |
throughput}
execute ping-option ttl <hops_int>
execute ping-option validate-reply {yes | no}
execute ping-option view-settings
Variable Description Default
data-size <bytes_int> Enter datagram size in bytes.This allows you to
send out packets of different sizes for testing the
effect of packet size on the connection. If you
want to configure the pattern that will be used to
buffer small datagrams to reach this size, also
configure pattern <bufferpattern_hex>.
56
df-bit {yes | no} Enter either yes to set the DF bit in the IP header
to prevent the ICMP packet from being
fragmented, or enter no to allow the ICMP packet
to be fragmented.
no
pattern <bufferpattern_hex> Enter a hexadecimal pattern, such as 00ffaabb,
to fill the optional data buffer at the end of the
ICMP packet. The size of the buffer is determined
by data-size <bytes_int>.
repeat-count <repeat_int> Enter the number of times to repeat the ping. 5
source {auto | <interface_ipv4>} Select the network interface from which the ping
is sent. Enter either auto or a FortiVoice network
interface’s IP address.
auto
timeout <seconds_int> Enter the ping response timeout in seconds. 2
tos {default | lowcost | lowdelay |
reliability | throughput}
Enter the IP type-of-service option value, either:
• default: Do not indicate. (That is, set the
TOS byte to 0.)
• lowcost: Minimize cost.
• lowdelay: Minimize delay.
• reliability: Maximize reliability.
• throughput: Maximize throughput.
default
ttl <hops_int> Enter the time-to-live (TTL) value. 64
validate-reply {yes | no} Select whether or not to validate ping replies. no
view-settings Display the current ping option settings.