Fortinet Technologies Inc. Page 142 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
entered secondary DNS setting instead of saving it to disk, the FortiVoice unit’s configuration
would therefore match the second output, not the first.
Most get commands, such as get system dns, are used to display configured settings. You
can find relevant information about such commands in the corresponding config commands in
the config chapter.
Other get commands, such as system performance, are used to display system information
that is not configurable. This chapter describes this type of get command.
This chapter describes the following commands.
If you have entered settings but cannot remember how they differ from the existing
configuration, the two different forms of get, with and without the object name, can be a useful
way to remind yourself.
system performance
system status
Although not explicitly shown in this section, for all config commands, there are related get
and show & show full-configuration commands which display that part of the
configuration. get and show commands use the same syntax as their related config
command, unless otherwise mentioned. For syntax examples and descriptions of each
configuration object, field, and option, see “config” on page 22.
To Next Page
Loading...
