Fortinet FortiVoice 200D - Page 16

Fortinet Technologies Inc. Page 16 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
Example of table commands
From within the system admin object, you might enter:
edit admin_1
The CLI acknowledges the new table, and changes the command prompt to show that you are
now within the admin_1 table:
new entry 'admin_1' added
(admin_1)#
get List the configuration of the current object or table.
• In objects, get lists the table names (if present), or fields and their
values.
• In a table, get lists the fields and their values.
purge Remove all tables in the current object.
For example, in config forensic user, you could type get to see
the list of user names, then type purge and then y to confirm that you
want to delete all users.
purge is only available for objects containing tables.
Caution: Back up the FortiVoice unit before performing a purge. purge
cannot be undone. To restore purged tables, the configuration must be
restored from a backup. For details, see backup.
Caution: Do not purge system interface or system admin tables.
purge does not provide default tables. This can result in being unable to
connect or log in, requiring the FortiVoice unit to be formatted and
restored.
rename
<table_name>
to
<table_name>
Rename a table.
For example, in config system admin, you could rename admin3 to
fwadmin by typing rename admin3 to fwadmin.
rename is only available within objects containing tables.
show Display changes to the default configuration. Changes are listed in the
form of configuration commands.
Table 3: Commands for fields
abort Exit both the edit and/or config commands without saving
the fields.
end Save the changes made to the current table or object fields,
and exit the config command. (To exit without saving, use
abort instead.)
get List the configuration of the current object or table.
• In objects, get lists the table names (if present), or fields
and their values.
• In a table, get lists the fields and their values.
Table 2: Commands for tables